Need more time at agreeing with hazards or police presence
When I get an alert for a hazards or police presence, the distance winds down to where the hazard or police is. The is a problem on roads that curve, because you don't see it immediately, by the time you do, the pop up disappears. I think that you should give it several hundred feet before it disappears. This alleviates the stress of agreeing with the sighting before it disappears.

-
Jeff Nieusma commented
the still there and not there buttons are too close together and above each other. they should be at the bottom of the screen and next to each other to prevent finger bounce from hitting the wrong button.
-
Anonymous commented
to see if the vehicle on the side of the road or the patrol officer is there. Remember if we are driving and looking out for ourselves, and a notification voice says, Vehicle on side of the road in 1.2 miles. We begin to look for that. Dividing now our attention between driving and looking ahead to see if there is still a car on the side or patrol person. I feel myself often rushed and straining to see up the road. If there is a curve, or a semi in front of me I can't do anything until its too late. The warning is gone and I can't help. I would only hope you could add a couple more seconds on showing that STILL THERE / NOT THERE message. ty
-
Anonymous commented
Just had Police ahead pop up and two buttons to click - one to say if they were still there, the other to say if they had gone - which is a great idea - but by the time we get to the place should have been, the buttons disappear and even pressing on the police symbol on the map doesn’t bring them back up. Can you delay the buttons displaying a bit longer or have the option to bring them back up please?
-
Rsgirl commented
Waze needs to enact this suggestion immediately.
-
Anonymous commented
I like this
-
Anonymous commented
Keep more time (in Brazil) the potholes harzard on road. Because in Brazil the potholes are difficult to been repared and i need to keep sending the alerts every single day. It will be easer and safer for wazer in my country if the alerts been keep for a week. That´s it!
-
Brian K commented
Leave Confirm/Deny (Yes/No) buttons on screen longer (Increase Countdown time) -
Because of the disparity of user entries adding alerts, the exact location of an alert is vague. Often times when I see an alert, the countdown to when I can confirm or deny goes away before the actual alert is there. There have been times I press Deny, only to see the alert around a corner or over a hill, a few tenths of a mile up the road. My suggestion is to leave those buttons on for 1/4 mile or so past the supposed alert to give more validity to the confirmations or denials. -
Darkon commented
I agree! When a marker is clicked it should have a "not there" button so we can remove the event. Maybe limit it to Knight Wazer or higher?
-
Scare Team 3 commented
An "Are you sure it's not there?" type confirmation window for whether or not a hazard is still in/on the road. Or perhaps a timer longer than 15s.
-
Anonymous commented
I need more time to confirm or "not there" hazards, police, etc. Why not 30 sec? There have been a few times when I pressed "not there" only to find that the hazard was just a little further down the road.
-
Anonymous commented
When the "not there" option pops up for hazards and police it often disappears before I arrive to where it should be so you aren't able to click 'not there' by the time you reach the mark. It should remain on the screen longer or be a clickable option when you open the hazard or police reporting.
-
Kent Smith commented
Yes I agree this would be good. I feel like I have too short a time to look for the object/item and then respond before it disappears from the screen.
-
Waveguider commented
Leave the Not here and thumbs up longer. I sometimes click one or the other only to see the car on the side of the road a few feet further o